Lenovo Q180 manual Replacing a memory module, To replace a memory module

Page 35

Step 7. Install the new hard disk drive as follows:

a.Slide the new hard disk drive into position and secure it to the chassis with the 4 screws. Step 8. Reattach the computer cover.

Replacing a memory module

Attention: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.

Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo recommends that you use a blanket, towel, or other soft cloth to protect the computer screen from scratches or other damage.

To replace a memory module

Step 1. Remove any media (disks, CDs, or memory cards) from the drives, shut down the operating system, and turn off the computer and all attached devices.

Step 2. Unplug all power cords from electrical outlets.

Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O) cables, and any other cables that are connected to the computer. Refer to “Left and right view” and “Rear view” for help with locating the various connectors.

Step 4. Remove the computer cover. Refer to “Removing the computer cover”.

Step 5. Push out the latches on both sides of the memory socket to release the memory module. Gently pull the memory module upward to remove it from its socket.

Chapter 8. Replacing hardware 29

Image 35

Contents IdeaCentre Q180 Hardware Maintenance Manual Page IdeaCentre Q180 Hardware Maintenance Manual Page Contents Iv IdeaCentre Q180Hardware Maintenance Manual About this manual Important Safety InformationIdeaCentre Q180Hardware Maintenance Manual Electrical safety Safety informationGeneral safety IdeaCentre Q180Hardware Maintenance Manual Handling electrostatic discharge-sensitive devices Safety inspection guideGrounding requirements Safety noticesTo Connect To Disconnect Do not≥18 kg37 lbs ≥32 kg70.5 lbs ≥55 kg121.2 lbs Environment SpecificationsGeneral information Type IdeaCentre Q180IdeaCentre Q180Hardware Maintenance Manual General Checkout IdeaCentre Q180Hardware Maintenance Manual Using passwords Using the Setup UtilityStarting the Setup Utility program Viewing and changing settingsSetting, changing, or deleting a Power-On Password Administrator PasswordSetting, changing, or deleting an Administrator password Select Save changes and Exit from the menu Enabling or disabling a deviceSelecting or changing the startup device sequence Exiting the Setup Utility programSelecting a startup device Selecting a temporary startup deviceUsing the Setup Utility IdeaCentre Q180Hardware Maintenance Manual Error FRU/Action Symptom-to-FRU IndexHard disk drive boot error Power Supply ProblemsPost Error Message Description/Action Post error codesUndetermined problems Front view Locating components, controls and connectorsLocations Rear view Hardware components Identifying parts on the motherboard General information Pre-disassembly instructionsReplacing hardware To replace the optical drive Replacing the optical driveTo remove the computer cover Removing the computer coverTo replace the hard disk drive Replacing the hard disk driveTo replace a memory module Replacing a memory moduleTo replace the Wlan card Removing the power buttonTo remove the power button Replacing the Wlan cardTo replace the CPU heatsink and system fan Replacing the CPU heatsink and system fanTo replace the motherboard Replacing the motherboardTo replace the keyboard and mouse Replacing the keyboard and mouseComputer Cover Q180 TOP case module 110200358 FRU listsItem # FRUs Motherboard Hard disk drivesWlan card Memory moduleSystem fan and heatsink Power buttonChassis Automatic Power-On features Additional Service InformationPower management Advanced configuration and power interface Acpi Bios