Lenovo 8212, 8154, 8214, 8165, 8213, 8162, 8161, 8164, 8211, 8163, 8111 manual Connecting drives

Page 36

7.Install the drive into the bay until it snaps into position.

8.Continue at “Connecting drives.”

Connecting drives

The steps to connect a drive are different depending on the type of drive you are connecting. Use one of the following procedures for your drive connection.

Connecting an optical drive or a parallel ATA hard disk drive

1.Locate the two-connector signal cable that comes with your computer or with the new drive.

2.Locate the PATA primary IDE connector on the system board. See “Identifying parts on the system board” on page 13.

3.Connect one end of the signal cable to the drive and the other to the PATA primary IDE connector on the system board.

4.Locate the extra four-wire power connector and connect it to the drive.

20User Guide

Image 36

Contents Page Page Page Page Contents Iv User Guide Important safety information Conditions that require immediate actionGeneral safety guidelines ServicePower cords and power adapters Extension cords and related devicesPlugs and outlets BatteriesCD and DVD drive safety Heat and product ventilationAdditional safety information Lithium battery noticeTo connect To disconnect Modem safety information Laser compliance statementPower supply statement Overview Information resourcesXiv User Guide Installing options FeaturesExpansion Operating systems, preinstalled varies by model Available options Specifications Supported operating positions Tools required Handling static-sensitive devicesInstalling external options Locating connectors on the front of your computerLocating connectors on the rear of your computer Connector Description Obtaining device driversOpening the cover Locating components Identifying parts on the system board Installing memory Installing PCI adapters What to do nextUser Guide Installing internal drives Drive specifications Installing a drive in bay Connecting drives Connecting an additional serial ATA hard disk drive Installing a diskette drive in bay What to do next Security features Identifying security locksRope Clip Integrated cable lock Password protection Changing the batteryInstalling options Erasing a lost or forgotten password clearing Cmos Closing the cover and connecting the cablesInstalling options User Guide Using the Setup Utility Starting the Setup Utility programViewing and changing settings Using passwordsPassword considerations User PasswordAdministrator Password IDE Drive User PasswordIDE Drive Master Password Setting, changing, and deleting a passwordResetting the hard disk drive and power-on password Using Security Profile by Device Selecting a startup deviceSelecting a temporary startup device Advanced settings Exiting from the Setup Utility programChanging the startup device sequence User Guide Updating flashing Bios from a diskette or CD-ROM Appendix A. Updating system programsSystem program Updating flashing Bios from your operating system Recovering from a POST/BIOS update failureAppendix B. Cleaning the mouse Cleaning an optical mouseCleaning a mouse with a ball User Guide Appendix C. Manual modem commands Basic AT commandsLow speaker volume Set Pulse dial as defaultSet Tone Dial as default Internal speaker on until carrier detectedExtended AT commands MNP/V.42/V.42bis/V.44 commands Fax Class 1 commands Fax Class 2 commandsVoice commands Appendix C. Manual modem commands User Guide Appendix D. Notices Television output notice TrademarksIndex Password Page Part Number 39J8154