provide any services to reset either the user
For how to remove the
Supervisor password
A supervisor password protects the system information stored in the ThinkPad Setup program. The user must enter the supervisor password in order to get access to the ThinkPad Setup program and change the system configuration.
Attention: If the supervisor password has been forgotten and cannot be made available to the service technician, there is no service procedure to reset the password. The system board must be replaced for a scheduled fee.
How to remove the power-on password
If no supervisor password has been set, do the following to remove the
1.Disable the
2.Remove the backup battery. For how to remove the backup battery, see “1050 Keyboard bezel, backup battery, and speaker assembly” on page 66.
3.Connect the ac power adapter and turn on the computer. Wait until the POST ends. After the POST ends, the password prompt does not appear. The
4.Disable the
If a supervisor password has been set and is known to the service technician, do the following to remove the
1.Turn on the computer.
2.When the ThinkPad logo is displayed, immediately press F1.
3.Type the supervisor password to enter the ThinkPad Setup program.
4.Select Security.
5.Select Password.
6.Select Power-On Password.
7.Type the current supervisor password in the Enter Current Password field. Then, leave the Enter New Password field blank, and press Enter twice.
8.In the Changes have been saved window, press Enter.
9.Press Fn+F10 to save changes and exit the ThinkPad Setup program.
How to remove the hard-disk password
Attention: If User only mode is selected and the user
To remove a user
1.Turn on the computer.
2.When the ThinkPad logo comes up, immediately press F1 to enter ThinkPad Setup.
3.Select Security.
4.Select Password.