Updating system programs, Using system programs

Chapter 6. Updating system programs

This chapter contains information about updating POST/BIOS and how to recover from a POST/BIOS update failure.

Using system programs

System programs are the basic layer of software built into your computer. They include the power-on self-test (POST), the basic input/output system (BIOS) code, and the Setup Utility program. POST is a set of tests and procedures that is performed each time you turn on your computer. BIOS is a layer of software that translates instructions from other layers of software into electrical signals that the computer hardware can execute. You can use the Setup Utility program to view and change the configuration and setup of your computer.

Your computer system board has a module called electrically erasable programmable read-only memory (EEPROM, also referred to as flash memory). You can easily update POST, BIOS, and the Setup Utility program by starting your computer using a flash update diskette or by running a special update program from your operating system.

Lenovo might make changes and enhancements to the POST/BIOS. When updates are released, they are available as downloadable files on the Lenovo Web site at http://www.lenovo.com. Instructions for using the POST/BIOS updates are available in a TXT file that is included with the update files. For most models, you can download either an update program to create a system-program-update (flash) diskette or an update program that can be run from the operating system.

Note: You can download a self-starting bootable CD/DVD image (known as an

.iso image) of the diagnostics program to support systems without a diskette drive from:

http://www.lenovo.com

Updating (flashing) BIOS from a diskette or a CD/DVD-ROM

This section describes how to update (flash) the BIOS using a diskette or a

CD/DVD-ROM. System program updates are available at:

http://www.lenovo.com/support

1.To update (flash) the BIOS:

vFrom a diskette, make sure the computer is turned off and insert a system program update (flash diskette). Then turn on the computer. The update begins.

vFrom a CD/DVD-ROM, make sure the computer is turned on. Insert the CD/DVD-ROM into the optical drive.

2.Turn on the computer. If it is on already, you must turn it off and back on again. The update begins.

3.When you are prompted to select a language, press the number on your keyboard that corresponds to the language and then press Enter.

4.When prompted to change the serial number, press Y.

5.Type in the seven character serial number of your computer and then press Enter.