Lenovo 8332 manual Server board subdivision, Server board I/O panel

8.89-cm (3.5-inch) form factor drive. In addition, two 6.35-cm (2.5-inch) boot drives can be installed in the boot drive module.

Note: A bay is defined as the space required to house a single 2.54-cm (1.0-inch) high 8.89-cm (3.5-inch) disk drive in its carrier module (limitation of 1 TB size).

At the rear, the chassis assembly accommodates one PSU and a server board subsystem.

A top cover on the enclosure provides access to the cooling fans and the server board subsystem.

Note: The enclosure cover should only be removed by qualified service personnel as it provides access to a service area. Upon replacement, the cover MUST be secured by tightening the lock mechanism to the locked position with a screwdriver.

Figure 6. Locking the enclosure cover

Server board subdivision

The server board subdivision consists of:

vAn Intel Server Board S5000PSL

vSlots for up to six low-profile 1.905-cm (3/4-inch) PCI cards, installed in a vertical orientation. The following PCBs are installed as standard configuration:

–An Intel RAID Controller SRCSATAWB, in the left-hand slot (when viewed from the rear)

vA boot drive module, which contains two 6.35-cm (2.5-inch) SATA boot drives

Server board I/O panel

The server board I/O panel consists of various connectors and LEDs.

Figure 7. Server board I/O panel connectors

6User Guide