Setting
Select one of the following options:
Ready | When the lamp has been fully cooled |
| down, the POWER indicator changes to fast |
| blinking. In this condition, the projection |
| lamp can be turned on if the input signal |
| is reconnected or any button on the top |
| control or remote control is pressed. |
Shut down | When the lamp has been fully cooled down, |
| the power will be turned off. |
Off | Power management function is off. |
✔Note:
• Factory default is “Ready: 5 min.”
On start
When this function is set to “On,” the projector will be automatically turned on just by connecting the AC power cord to a wall outlet.
✔Note:
•Be sure to turn off the projector properly (see “Turning Off the Projector” on page 25). If the projector is turned off in the incorrect sequence, the On start function does not work properly.
•When the Standby mode is set to “Eco“ in the Setting, the On start funcion is disabled. (p.54)
Power management
Press the SELECT button at Power management and this dialog box appears. Use the Point 7 8 buttons to choose one of the three options.
Press the Point d button to select the timer, and then use the Point 7 8 buttons to set timer.
Slant
This function is used to set the cooling fans’ operation to the projector’s setting environment. Set this function properly in accordance with the projector’s installation method. Otherwise, the cooling fans will not work properly and that causes malfunctions of the projector and decreases the lamp life.
Select the projector’s installation condition from the following options:
Off .....When using the projector within the range of the upward/
downward inclination of ±70º and +110º~ +180º,
L1 ......When using the projector within the range of the upward/
downward inclination of +70º~+110º to the horizontal plane.
L2 ......When using the projector within the range of the upward/
downward inclination of
L3 ......When using the projector within the range of the upward/
downward inclination of ±70º to the horizontal plane and the ceiling function is set to “On”.
L4 ......When using the projector within the range of the upward/
downward inclination of +110º~+180º,
Slant setting
+70°
UP
+0°UP 
UP
UP
L1
L2
UP
+110°
“L4” at Ceiling “Off”
UP | “Off” at Ceiling “On” |
| |
| +180° |
UP |
|
| |
UP | “L3” at Ceiling “On” |
| “Off” at Ceiling “Off” |
|
55