Sanyo PLC-XT16 Indicators Projector Condition, Appendix Indicators and Projector Condition

APPENDIX

INDICATORS AND PROJECTOR CONDITION

Check the Indicators for projector condition.

	Indicators			Projector Condition
LAMP	WARNING	READY	LAMP
REPLACE	TEMP.
		green	red
yellow	red
				The projector is OFF. (The AC Power Cord is unplugged.)
✽				The projector is READY to be turned on with the POWER ON-
				OFF button.
✽				The projector is operating normally.
				The temperature inside the projector is abnormally high. The
				projector cannot be turned on. When the projector is cooled
✽				down enough and the temperature returns to normal, the READY
				indicator lights green and the projector can be turned on. (The
				WARNING TEMP. indicator keeps flashing.) Check and clean
				the Air Filter.
				The projector is cooled down enough and the temperature
✽				returns to normal. When turning on the projector, the WARNING
				TEMP. indicator stops flashing. Check and clean the Air Filter.
✽				The projector is being cooled down. It cannot be turned on until
				the READY indicator lights green.
				The projector detects an abnormal condition and cannot be
				turned on. Unplug the AC Power Cord and plug it again to turn
✽				on the projector. If the projector is turned off again, disconnect
				the AC Power Cord and contact the dealer or the service center
				for service and checkup. Do not leave the projector on. It may
				cause electric shock or a fire hazard.

✽

The projector is in the Power management mode.

• • • on • • • flashing • • • dim • • • off

✽When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow. When this indicator lights yellow, replace the projection lamp with a new one promptly. Reset the Lamp Replace Counter after replacement of the lamp.

47