Computer Input
Input Source Selection
Direct Operation
Choose Computer 1 or Computer 2 by pressing the INPUT button on the top control or press the COMPUTER button on the remote control.
Before using these buttons, correct input source should be selected through Menu operation as described below.
Top Control
INPUT button
Computer 1
Computer 2
Video
Remote Control
COMPUTER button
Computer 1
Computer 2
See Note at the bottom of this page.
Menu Operation
1 Press the MENU button to display the
2 Press the Point ▲▼ buttons to move the red arrow pointer to either Computer 1 or Computer 2, and then press the SELECT button.
3 After the Source Select Menu appeared for Computer 1, move the pointer to RGB and then press the SELECT button.
Note:
•When the Input Search function is set On1 or On2, the input signal will be searched automatically. (p.45)
•Computer 2 is not displayed when the COMPUTER IN 2 / MONITOR OUT terminal is set as Monitor out. (p.45)
•Computer 2 (COMPUTER IN 2 / MONITOR OUT) can accept only RGB signal.
Input Menu | Input Menu icon |
Move the pointer (red arrow) to Computer 1 and press the SELECT button.
Computer
1
Source Select Menu
Move the pointer to RGB and press the SELECT button.
Input Menu
M o v e t h e p o i n t e r t o COMPUTER 2 and press the SELECT button.
25