Sanyo PLC-XW57 Input Source Selection S-Video, Component, RGB Scart 21-pin, Top Control

Video Input

Input Source Selection (S-Video, Component, RGB Scart 21-pin)

Direct Operation

Choose Computer 1 by pressing the INPUT button on the top control or press the COMPUTER button on the remote control.

Before using these buttons, correct input source should be selected through Menu operation as described below.

Menu Operation

1 Press the MENU button to display the On-Screen Menu. Press the Point ◄► buttons to move the red framed pointer to the Input Menu icon.

Top Control

INPUT button



Remote Control

COMPUTER button



See Note at the bottom of this page.

Input Menu icon

2	Press the Point ▲▼ buttons to move the red arrow
	pointer to Computer 1 and then press the SELECT
	button.
3	After the Source Select Menu appeared for
	Computer 1, move the pointer to S-Video,

Component or RGB (Scart) and then press the SELECT button.

W h e n S - v i d e o i n p u t s i g n a l i s connected to the COMPUTER IN 1/S-VIDEO IN/COMPONENT IN jack, select S-Video.

When the input source is coming from video equipment connected to the COMPUTER IN 1/S-VIDEO IN/COMPONENT IN terminal with

aComponent-VGA Cable, select Component.

When the input source is coming from video equipment connected to the COMPUTER IN 1/S-VIDEO IN/ COMPONENT IN terminal with a Scart- VGA Cable, select RGB (Scart).

Note:

•When the Input Search function is set On1 or On, the input signal will be searched automatically (p.45)

•When Monitor out is selected in the Terminal function (p.45), Computer  is not displayed.

Input Menu

Move the pointer (red arrow) to Computer 1 and press the SELECT button.

Computer

1

Source Select Menu

Move the pointer to

S-video, Component or

RGB (Scart) and press the

SELECT button.

35