Appendix
Image is Left/Right reversed | – Check the Ceiling/Rear function. (See page 45.) | |
Image is Top/Bottom reversed | – Check the Ceiling function. (See page 45.) | |
|
| |
No sound | – Check audio cable connections from the audio input source. | |
| – Adjust the audio source. | |
| – Press the VOLUME + button. (See page 23.) | |
| – Press the MUTE button. (See page 23.) | |
| – Is the image projected? You will hear the sound only when the | |
| image is projected. | |
The color is strange.. | – Check the Input signal, color system,video system or | |
computer system mode. | ||
| ||
| – Make sure the "Blackboard" is not selected on Image select | |
| menu. (see pages 30, 31, 37.) |
Some displays are not seen during operations
– Check the Display item. (See page 42.)
Auto PC adjustment function | – Check the Input signal. Auto PC function can not work when |
does not work.. | 480p,575p.720p,480i,575i,1035i or 1080i is selected. (see |
| Page 27) |
The setting does not remain after turning off power..
–Make sure you selected "Store" after adjusting setting. Some settings can not be stored if not registered with "Store". (see pages 29, 32, 39)
Power management does not | – Power management function can not work while "Freeze" or | |
work.. | "No Show" function is running. (see pages 23, 24) | |
|
| |
Capture function does not work.. | – Check the connection and the input signal to see if there is | |
signal. | ||
| ||
|
| |
The image is distorted or runs | – Check "PC adjustment" menu or "Screen" menu and adjust | |
off.. | them. (see pages | |
|
| |
PIN code dialog box appears at | – PIN code lock is being set. Input a PIN code (1234 or numbers | |
the | you have set). (See pages 18, 48 and 49.) | |
|
| |
Computer 2 cannot be selected | – Select Computer 2 at the Terminal function. (See page 45.) | |
|
| |
The Terminal function cannot be | – The Terminal function cannot be selected after Computer 2 is | |
selected | selected. Select other input source such as Computer 1 or | |
| Video with the COMPUTER button or the VIDEO button on the | |
| remote control so that the Terminal function can be selected. |
The Remote Control does not work..
–Check the batteries.
–Make sure there is no obstruction between the projector and remote control.
–Make sure you are not too far from the projector when using the remote control. Maximum operating range is 16.4' (5 m).
–Make sure the code of the remote control is conformed to that of the projector. (See page 47.)
57