Sanyo PLC-XW56 owner manual Lamp Replacement, Reset the lamp replacement counter

Maintenance and Cleaning

Lamp Replacement

When the life of the projection lamp of this projector	TOP CONTROL
draws to an end, the LAMP REPLACE indicator emits
a yellow light. If this indicator lights yellow, replace the
lamp with a new one promptly.
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER

T h i s i n d i c a t o r i s yellow when the life of the projection lamp draws to an end.

CAUTION CAUTION

Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot.

For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.

Follow these steps to replace the lamp.

1	Turn off the projector and disconnect the AC power
	cord. Allow the projector to cool for at least 45
	minutes.
2	Loosen the screw with a screwdriver, and remove
	the lamp cover.
3	Loosen the 3 screws of the lamp with a screwdriver
	and lift the lamp out of the projector by using the
	built in handles.
4	Replace the lamp with a new one and secure it
	with the 3 screws. Make sure that the lamp is set
	properly. Replace the lamp cover and tighten the
	screw.
5	Connect the AC power cord to the projector and
	turn on the projector.
6	Reset the lamp replacement counter..
	See "Lamp Replacement Counter" on the next

page .

Lamp Cover Screw

Screw

LampScrew

Screw

Handles

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.

● Model No. of your projector: PLC-XW56

●Replacement Lamp Type No.: POA-LMP107

(Service Parts No. 610 330 4564)

54