Powering On/Off the Projector
Powering on the projector:
1.Remove the projector lens cap.
2.Complete the AC power cord and peripheral signal cable(s) connections.
3.Press ON /
4.Turn on your source (computer, notebook, DVD, etc.). The projector automatically detects your source.
When searching message appears on the screen, ensure that the appropriate signal cable(s) are securely connected.
The signal message will appear on the screen when the source is detected. If you are connecting multiple sources to the projector simultaneously, press INPUT button.
Remove the lens cap first before powering on.
Never look into the lens when the lamp is on. This can damage your eyes. It is especially important that children are not allowed to look into the lens.
To avoid image sticking, it is not recommended that you project the same still image for more than 15 minutes.
Faster
Powering Off the Projector:
1.Press ON /
2.Press ON /
3.The cooling fans continue to operate for cooling cycle and the Lamp LED goes out. When the Power LED begins flashing, the projector has entered standby mode.
If you wish to turn the projector back on, you must wait until the projector has completed the cooling cycle and has entered standby mode.
Once in standby mode, simply press ON /
4.Disconnect the power cord from the electrical outlet and the projector.
Please wait until the fan motor and the Lamp LED turn off before removing the AC power cord from the projector.
Faster