Sanyo PDG-DWL100 owner manual Lamp Counter Reset, Security Settings, Factory Default

User Controls

Volume:

■Press the to decrease the volume.

■Press the to increase the volume.

Lamp Counter Reset

Reset the lamp life hour after replacing a new lamp.

Security Settings

Security Settings:

■On: Choose “On” to enable security verification when turning on the projector.

■Off: Choose “Off” to be able to switch on the projector without password verification.

Note

Password default value is “1234” (first time).

If you input incorrect password 3 times, the projector will automati- cally shut itself down and enter into standby mode.

Change Password:

■First Time:

1.Press “ENTER” to set the password.

2.Use number buttons to enter default password and then press

“ENTER” to confirm.

3.Use number buttons on the remote to enter your new pass- word and then press “ENTER” to confirm. (The password has to be 4 digits.)

4.Enter new password again and press “ENTER” to confirm.

■Change Password:

1.Press “ENTER” to input old password.

2.Use number buttons to enter current password and then press

“ENTER” to confirm.

3.Enter new password (4 digits in length) using the number but- tons on the remote, then press “ENTER” to confirm.

4.Enter new password again and press “ENTER” to confirm.

Factory Default

Return the adjustments and settings to the factory default values. (except for lamp counter and security setting)

29

English

English