OPERATIONS (continued)
No Signal Menu
The same adjustments and settings are available as with the Image and Options menus when the MENUO button is pressed during display of the ‘NO INPUT IS DETECTED ON ***’ or ‘SYNC IS OUT OF RANGE ON ***’ message while no signal is received. See Table 1.7 below.
Table 1.7 No Signal Menu
VOLUME
KEYSTONE BLANK 
MIRROR 
START UP 
MENU COLOR 
TIMER
LANGUAGE 
AUTO OFF 
SYNC ON G 
40
+1
ENGLISH
Item | Description |
|
| |||
VOLUME | Volume adjustment: Reduce VOLUME | ↔ Increase VOLUME | ||||
|
|
|
|
|
| |
KEYSTONE | Adjustment: |
|
|
|
| |
Reduce size of bottom of image | ↔ Reduce size of top of image | |||||
| ||||||
|
|
|
| |||
| Select blank screen color: Select color with the | and | buttons. | |||
BLANK | * The image is cleared when the BLANK MODE is set with BLANK ON, | |||||
or when there is no signal, and the entire screen is displayed in the | ||||||
| selected color. Note that if TURN OFF is selected on the START UP | |||||
| the blank screen is displayed in blue when there is no signal. | |||||
|
|
|
|
|
| |
MIRROR | Operation start/stop: Press the | or | button. |
|
| |
Select Mirror status: Select mirror status with | and | buttons. | ||||
| ||||||
|
|
|
|
|
| |
| Operation start/stop: Press the | or | button. |
|
| |
START UP | Setup initial screen display: Select TURN ON with the | button. | ||||
Clear initial screen display: Select TURN OFF with the | button. | |||||
| ||||||
*Note that if TURN OFF is selected the blank screen is displayed in blue when there is no signal.
MENU COLOR | Select menu background color: Select with the | and | buttons. | ||||
|
|
|
|
|
| ||
TIMER | Operation start/stop: Press the | or | button. |
|
| ||
Setup initial timer value: Set 1~99 minutes with the | and | buttons. | |||||
| |||||||
|
|
|
|
|
| ||
LANGUAGE | Operation start/stop: Press the | or | button. |
|
| ||
Select menu display language: Select with the | and | buttons. | |||||
| |||||||
|
|
|
|
|
| ||
| Operation start/stop: Press the | or | button. |
|
| ||
| Set AUTO OFF: Set 0~99 minutes with the | and | buttons. | ||||
AUTO OFF | The system automatically enters the standby mode when a signal is | ||||||
not received for the set time. |
|
|
|
|
| ||
| Clear AUTO OFF: Select STOP (0 min.) with the | button. |
| ||||
| Wind Stop is selected the system does not enter the standby mode | ||||||
| even if no signal is received. |
|
|
|
|
| |
Operation start/stop: Press the 
or 
button.
SYNC ON G valid: Select TURN ON with the 
button.
SYNC ON G | SYNC ON G invalid: Select TURN OFF with the button. |
*When SYNC ON G is effective, it may not be displayed normally by an input signal. Remove a signal connector, and make it condition without a signal, and input a signal again in this case SYNC ON G after it is overridden.