SYSTEM CONNECTION
Connect each speaker to the corresponding speaker terminals on your receiver or amplifier.
If you are using a subwoofer, follow the directions in that owner’s guide to connect and configure it.
Configure your receiver or processor to reflect the correct number of speakers in your system. If you have added one SCSSAT500/300/200 speaker to a
6.1system. If you have added two SCS SAT500/300/200 speakers to a
7.1system.
The SCS SAT500/300/200 should be set to “Small.” If your receiver allows you to set the crossover frequency between the subwoofer and the speakers, select 100Hz or the setting that is the closest frequency below it.
Left Front
–+
Center | Right Front | ||
– | + | – | + |
|
| ||
Subwoofer
LFE In
|
| Receiver |
|
|
Left |
| Subwoofer | Right | |
Front |
| Out | Front |
|
– | + |
| – | + |
– +
|
|
| Center |
|
|
| |
| Left | Surround Back | Surround Back | Right | |||
Surround |
| Left |
| Right | Surround | ||
– | + | – | + | – | + | – | + |
Left Surround
–+
Right Surround
–+
–+
–+
Surround Back Surround Back
LeftRight
6