Speaker Connections, Listening position may

Such damage would not be covered under the warranty.

Step 7: Holding the Satellite Speaker ¶ with both hands, reinsert the ball portion of the Ball and Shaft £ into the Attachment Plate ¢.

Step 8: Hand-tighten the Molded Nut ™ while posi- tioning the speaker for the desired orientation. If the Molded Nut ™ is difficult to tighten by hand, insert the Metal Bar ∞ into one of the holes in the outer edge of the Molded Nut ™ and use the bar as a lever. Be careful

not to cross-thread. The swiveling ball enables you to aim the speaker to one side or the other, or to tilt it up or down. Although stereo imaging may be improved by aiming the front speakers toward the listening position, especially for music selec- tions, the surround speakers are intended to provide a dif- fuse, ambient sound that is best achieved by aiming the speakers straight out from the wall. Aiming the sur- round speakers toward

the listening position may

ruin the intended effect by calling too much attention to the information in those channels.

Step 9: Once the speaker’s orientation has been final- ized, insert the Metal Bar ∞ into one of the holes in the outer edge of the Molded Nut ™ and tighten the Molded Nut ™ securely. Keep the Metal Bar ∞ in a safe place, in the event that you decide to adjust the speaker’s orientation in the future.

SPEAKER CONNECTIONS

CONNECTION TIPS

Separate and strip the ends of the speaker wire as shown. The wires sup- plied with the system may already be stripped and tinned for easy insertion into the speaker terminals. You may need to separate the two conductors further in order to thread them through the shelf stand or floor stand adapter. Speakers and elec- tronics terminals have corre- sponding (+) and (–) terminals. Most manufacturers of speakers and electronics, including JBL, use red to

denote the (+) terminal and black to denote the (–) terminal.

The (+) lead of the speaker wire is noted with a stripe. It is important to connect both speakers identically:

(+)on the loudspeaker to

(+)on the amplifier and (–) on the loudspeaker to (–) on the amplifier. Wiring “out of phase” results in thin sound, weak bass and a poor stereo image.

With the advent of multi- channel surround sound systems, connecting all of the speakers in your system with the correct polarity remains equally important in order to preserve the proper ambience and directionality of the program material.

To connect the supplied speaker wires to the satellite

and center speaker terminals, press the red or black plastic cap for the desired terminal, insert the bare end of the wire into the hole below the cap and release the cap. Gently tug on the wire to make sure that it is fully inserted.