TROUBLESHOOTING
If there is no sound from any of the speakers:
•Check that receiver/amplifier is on and a source is playing.
•Check all wires and con- nections between receiver/ amplifier and speakers. Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured, or touching each other.
•Review proper operation of your receiver/amplifier.
If there is no sound coming from one speaker:
•Check the “Balance” control on your receiver/amplifier.
•Check all wires and con- nections between receiver/ amplifier and speakers. Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured, or touching each other.
•In Dolby® Digital or DTS® modes, make sure that the receiver/processor is con- figured so that the speaker in question is enabled.
•Turn off all electronics and switch the speaker in question with one of the other speakers that is working correctly. Turn everything back on, and determine whether the problem has followed the speaker, or has remained in the same channel. If the problem is in the same channel, the source of the problem is most likely with your receiver or amplifier, and you should consult the owner’s manual for that product for further informa- tion. If the problem has
followed the speaker, con- sult your dealer for further assistance or, if that is not possible, visit www.jbl.com.
If the system plays at low volumes but shuts off as volume is increased:
•Check all wires and con- nections between receiver/ amplifier and speakers. Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured, or touching each other.
•If more than one pair of main speakers is being used, check the minimum impedance requirements of your receiver/amplifier.
If there is low (or no) bass output:
•Make sure the connections to the left and right “Speaker Inputs” have the correct polarity (+ and
•If your system includes a subwoofer, check its oper- ation and the configuration of your receiver or proces- sor. If your system has no subwoofer, consider adding a powered subwoofer.
If there is no sound from the surround speakers:
•Check all wires and con- nections between receiver/ amplifier and speakers. Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured, or touching each other.
•Review proper operation of your receiver/amplifier and its surround sound features.
•Make sure the movie or TV show you are watching is recorded in a surround sound mode. If it is not, check to see whether your receiver/amplifier has other surround modes you may use.
•In Dolby Digital or DTS modes, make sure your receiver/processor is con- figured so that the surround speakers are enabled. When five satellites are in use, remember to configure your receiver or processor for
•Review the operation of your DVD player and the jacket of your DVD to make sure that the DVD features the desired Dolby Digital or DTS mode, and that you have properly selected that mode using both the DVD player’s menu and the DVD disc’s menu.
7