Hitachi CP-X950W, CP-x950E specifications For the Customers in U.K

Page 2

FOR THE CUSTOMERS IN U.K

THIS PRODUCT IS SUPPLIED WITH A TWO PIN MAINS PLUG FOR USE IN MAINLAND EUROPE. FOR THE U.K PLEASE REFER TO THE NOTES ON THIS PAGE.

IMPORTANT FOR UNITED KINGDOM

WORDING FOR CLASS I EQUIPMENT INSTRUCTION BOOKS AND LABELS

The mains lead on this equipment is supplied with a moulded plug incorporating a fuse, the value of which is indicated on the pin face of the plug. Shoud the fuse need to be replaced, an ASTA or BSI approved BS 1362 fuse must be used of the same rating. If the fuse cover is detachable never use the plug with the cover omitted. If a replacement fuse cover is required, ensure it is of the same colour as that visible on the pin face of the plug. Fuse covers are available from your dealer.

DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer.

Shoud it be necessary to change the mains plugs, this must be carried out by a competent person, preferable a qualifiedelectrician.

If there is no alternative to cutting off the mains plug, ensure that you dispose of it immediately, having first removed the fuse, to avoid a possible shock hazard by inadvertent connection to the mains supply.

WARNING: THIS EQUIPMENT MUST BE EARTHED IMPORTANT:

The wires in the mains lead are coloured in accordance with the following code: Green and Yellow = Earth, Blue = Neutral, Brown = Live.

Green & Yellow to Earth

Blue to Neutral

Brown to Live

Fuse

Cord Clamp

As these colours may not correspond with the coloured makings identifying the terminals in your plug, proceed as follows:

The wire which is coloured Green and Yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or coloured Green or Green and Yellow.

The wire coloured Blue must be connected to the terminal marked with the letter N or coloured BLUE or BLACK. The wire coloured BROWN must be connected to the terminal marked with the letter L or coloured BROWNorRED.

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Outline FeaturesContents Operating GuideFor the Customers in U.K Before use Video signal cablesPower cord Video inputsDo not use power supplies Do not look directly at the lens when the lamp is litDo not install this unit in an unstable If any abnormality occursBe careful in handling the power cord Do not stare directly into the laser ApertureClean inside the unit at least once two years Handle the power cord carefullyCleaning When you are not going to use for a long timeCleaning the lens Do not place this unit where it gets hotVolume Cleaning the cabinetStandby / on Names and functions of each partMain unit Disk PAD Remote control transmitterLaser on ¡ Remove the battery Compartment cover Names and functions of each partView from the top View from the side InstallationInstallation of liquid crystal projector View from the front View from the sideTurn the Main Power switch of the projector on. I on Press the STANDBY/ON button, for 1 second Basic operationsPlug & Play Adjustments and functions Press the Menu buttons or the Menu on / OFF buttonColor SET UPBrightness SizeInput ImageReveal OPT. OptionBlank Language COM. BitsConnection to the video signal terminals Connection to the RGB signal terminalConnection to the RGB signal terminal Example of computer signalConnection to the RGB signal terminal Initial set signalsMouse emulation Connection to the control signal terminalControl signal terminal Connection to the control signal terminal Control command code CommunicationControl data table Procedure of getting the Projector status Connecting various equipment Example of system setupCleaning the air filter Lamp Clean the air filter using a vacuum cleanerRe-install the air filter Message tableWhen you think something wrong Indicator displayDimension diagram
Top Page Image Contents