Hitachi CP-X870 user manual Turning on the Power, Selecting an Input Signal

TURNING ON THE POWER (continued)

Selecting an Input Signal

5

Using the remote control

If selecting RGB input

Press the RGB button

Press this button to toggle between the devices connected to RGB IN 1 and 2. As illustrated below, each time you press the RGB button, the projector switches between RGB IN 1 and 2. Select the signal you wish to project.

• When BNC (RGB) is selected: RGB

RGB BNC(RGB) DVI

•When BNC (COMPONENT) is selected:

RGB DVI

If selecting video input Press the VIDEO button

Press this button to toggle between the	VIDEO
devices connected to VIDEO IN, S-VIDEO
IN and COMPONENT VIDEO. As
illustrated below, each time you press the

VIDEO button, the projector switches between VIDEO IN, S-VIDEO IN and COMPONENT VIDEO. Select the signal you wish to project.

•When BNC (RGB) is selected:

VIDEO IN S-VIDEO IN COMPONENT VIDEO

•When BNC (COMPONENT) is selected:

VIDEO IN S-VIDEO IN COMPONENT VIDEO

BNC(COMPONENT)

Using the projector's control panel

Turn the INPUT dial

Turning the dial cycles	B INPUT
through the inputs as
shown below. Select the
terminal to which the signal
you want to project is input.

•When BNC (RGB) is selected:

RGB BNC(RGB) DVI

COMPONENT VIDEO S-VIDEO VIDEO

•When BNC (COMPONENT) is selected:

RGB BNC(COMPONENT) DVI

COMPONENT VIDEO S-VIDEO VIDEO

NOTE

Turn the INPUT dial and set it at the click point, otherwise input signal selection may be incorrect.

6	Use the ZOOM	/	buttons to adjust	ZOOM
	the screen size				ZOOM
				(Control panel)	(Remote control)
7	Use the FOCUS	/	buttons to adjust	FOCUS
	the focus				FOCUS
				(Control panel)	(Remote control)

16