NEC204 Eng.Fr.manual 10/26/98 10:20 AM Page 13
Step 5 After the adapter plate |
|
|
has been attached to |
|
|
the base, snap the base |
| Figure 4D |
assembly to the monitor. |
|
|
To accomplish this, position |
|
|
all the locking tabs on |
|
|
the base so they mate |
|
|
with the holes in the |
|
|
monitor. Slide the base |
|
|
assembly in place as |
|
|
shown in Figure 4D. |
|
|
Step 6 Using two of the |
|
|
screws that were |
|
|
Figure 4E |
| |
removed in Step 2, |
| |
|
| |
|
| |
attach the adapter |
|
|
plate assembly to |
|
|
the monitor. To |
|
|
accomplish this, it |
|
|
will be necessary |
|
|
to turn the adapter |
|
|
plate fully counter- |
|
|
clockwise while sliding it |
|
|
forward as shown in Figure 4E. This will allow you to install the | ||
two rear screws. |
|
|
Step 7 Using the remaining screw |
| Figure 4F |
that was removed in Step 2, |
|
|
complete attachment of the |
|
|
adapter plate assembly. To accomplish this, it will
be necessary to slide
the adapter plate backwards as shown in Figure 4F.
9