NEC204 Eng.Fr.manual 10/26/98 10:20 AM Page 12
Step 2 Using a Phillips screwdriver, remove the three screws securing the original base to the monitor. Remove the base by sliding and lifting as shown in Figure 4A. Save these screws for use in Steps 6 and 7. Save the original base for possible future use.
Figure 4A
ORIGINAL MOUNTING
Step 3 Using a Phillips | Figure 4B |
screwdriver, remove |
|
the screw securing |
|
the two base |
|
halves together |
|
as shown in |
|
Figure 4B. |
|
Retain the screw |
|
and black nylon |
|
washer for |
|
use in the next step. |
|
RETAIN
THESE PARTS TO USE IN NEW MOUNTING
Step 4 Locate Adapter Plate “B” | NEW MOUNTING |
| |
that is supplied with | Figure 4C |
the IntelliBase™ and secure |
|
it to the spindle using the |
|
screw and black nylon |
|
washer that was removed |
|
in Step 3 as shown in |
|
Figure 4C. |
|
BASE
ADAPTER PLATE (B)
8