Epson instruction manual Installing & Setting up the Epson D88 printer, After installation

Installing & Setting up the Epson D88 printer

Insert the Epson Stylus D88 software CD-ROM into your CD-ROM drive. The CD will auto run. Select 'Custom Install' from the menu, as in diagram 1 below. When Diagram 2 appears click 'Printer Driver'. It will display diagram

3, click OK and it will copy files to your computer. Make sure the USB cable is connected to the PC and printer, then turn on the printer as instructed in diagram 4. After the utility has found your printer it will confirm this as in diagram 5. The Epson D88 has now been successfully installed. Click OK.

Now follow the Epson D88 driver setup below.

Diagram 1 Diagram 2

Diagram 3

Diagram 4

Diagram 5

After installation

The Epson Status Monitor needs disabling before use. Follow the below steps.

1.Go to the printers and faxes folder.

2.Right click on the D88 and select properties.

3.Click printing preferences.

4.Click the Maintenance tab.

5.Click on the 'Speed & Progress' button.

6.Un-tick 'Show Progress Meter'.

7.Un-tick 'Disable EPSON status monitor 3'.

8.Click OK three times to close the driver boxes down.

Browse to the Printers and Faxes folder. Right click on the Epson D88 printer and click on 'Properties'. Click on 'Printing preferences as in diagram 6, then follow the diagrams below.

Diagram 6 Diagram 7 Diagram 8

Click

Advanced

1	3
2
	4

1. Epson Matte

2. Photo

3. ICM

4. Off (No Color Adjustment)

Diagram 9	Diagram 10	Diagram 11
1	1

2Click

Mirror Image	Name it
	Subli-print
	Click
	Save Setting
2	Click 'Save' then click	1
	OK until all open boxes
	are closed.