Quick Start Reference Sheet

Epson EMP-7800

Revision D

NOTE: This document is intended only as a quick reference for installation – please read the SP Controls Application Note for a complete description of this projector driver prior to installation.

I. Driver Features

1.Input Selection Mapping

Selection 1: VIDEO (RCA)

Selection 2: S-VIDEO

Selection 3: YPbPr (BNC)

Selection 4: COMPUTER (VGA)

2.Hidden Function Mapping (Default Configuration)

Using the ON button as a shift key, press the following buttons to access the specified projector features.

Selection 1: ESC

Selection 2: ENTER

Selection 3: ADJUST LEFT

Selection 4: ADJUST RIGHT

Off: MENU

Volume Up: ADJUST UP

Volume Down: ADJUST DOWN

3. Other Driver Features

Power Status Feedback Method	RS-232	Power Polling
Control Wiring:	RS-232	Only

II. Wiring Specifications

Although this driver does not use IR, SP Controls strongly recommends wiring for RS-232 and IR. Under certain conditions it may be necessary to control this projector through IR – see the Special Control Note in the Application Note below for more information.

NOTE: For a wiring diagram, please see the SP Controls Application Note.

Wire the Panel RS-232 port to a female DB9 as follows:

TX to 2

RX to 3

GND to 5

Connect this female DB9 to the projector port labeled CONTROL (RS-232C).

Wire the Panel IR/Serial port to a female 1/8" Mini as follows:

IR/SER to tip

GND to ring

Connect to the included IR Emitter and attach the emitter bud to the rear projector IR window. Note that

the projector does not consistently respond when the IR emitter is attached to the front IR window.

DR-EPS19 – 3/29/04 SP Controls reserves the right to modify specifications without notice at any time.