Epson DR-EPS19 quick start III. Additional Projector Information, Help@spcontrols.com

Page 2

SmartPanel Projector Driver Application Note

Epson EMP-7800

III. Additional Projector Information

NOTE: For use with this driver, the Epson EMP-7800 should be running projector firmware version 2.05 or higher. For information on how to check your projector firmware version and instructions on how to upgrade if necessary, see the Projector Firmware Note in the Application Note below.

NOTE: The Epson STANDBY MODE must be set to NETWORK ON in the projector ADVANCED1 onscreen menu or the projector may stop responding to RS-232 commands. See the Special Control Note 1 in the Application Note below for more information.

NOTE: Several additional projector settings must be correctly configured for the Epson EMP-7800 to work with the SmartPanel. See Special Control Note 2 in the Application Note below for more information.

•STARTUP SCREEN should be set to OFF in the ADVANCED1 Menu.

•COM PORT must be set to RS-232 in the ADVANCED2 menu.

•SLEEP MODE should be set to OFF in the SETTING Menu.

•DISPLAY MESSAGE should be set to OFF in the SETTING Menu.

© 2004 SP Controls Inc. 601 Minnesota Suite 115, San Francisco, CA 94107

help@spcontrols.com

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Quick Start Reference Sheet Driver FeaturesII. Wiring Specifications Help@spcontrols.com III. Additional Projector InformationSmartPanel Projector Driver Application Note Projector Control Volume and Power ControlProjector Driver Application Note Hidden Function MappingOther Presets RelaysII. Control Wiring Control RS-232CIII. Projector Firmware Note VI. Revision History IV. TroubleshootingTechnical Notes Projector is not responding to Panel control
Top Page Image Contents