203 Eng Fr Cndn manual 12/21/98 11:19 AM Page 6
Quick Start
How to attach IntelliBase™ USB Hub and Audio to your MultiSync® brand monitor
THE INTELLIBASE USB HUB AND AUDIO WILL ONLY WORK WITH THE MULTISYNC BRAND MONITORS LISTED BELOW. DO NOT ATTEMPT TO CONNECT THE INTELLIBASE WITH ANY OTHER MONITOR BRANDS.
MAKE SURE THE MONITOR IS DISCONNECTED FROM THE SYSTEM AND IS UNPLUGGED FROM THE WALL OUTLET BEFORE ANY WORK IS DONE ON THE MONITOR.
FOR ALL 21” MULTISYNC MONITORS
IT IS ADVISED THAT TWO PEOPLE ARE INVOLVED DURING THE ENTIRE INSTALLATION PROCESS. ONCE THE INTELLIBASE HAS BEEN INSTALLED ONTO YOUR 21” MONITOR, DO NOT ATTEMPT TO ADJUST THE TILT OF THE MONITOR FROM THE BACK OF THE MONITOR UNIT. ONLY ADJUST THE TILT FROM THE FRONT OF THE UNIT BY HOLDING ONTO THE LEFT AND RIGHT SIDE OF THE MONITOR, TILTING EITHER UPWARDS OR DOWNWARDS. DO NOT TILT THE MONITOR DOWNWARDS MORE THAN 5 DEGREES OR FORCE THE MONITOR PAST THE FIRST STOP, AS THE MONITOR MAY BECOME UNSTABLE, CAUSING POSSIBLE INJURY.
If you have any questions or comments, please contact NEC at
To attach the IntelliBase to your MultiSync brand monitor, the original base must first be removed. Depending on the model of your MultiSync brand monitor, the removal procedure of the original base and the attachment of the IntelliBase will vary. Locate the model name (located in the lower right corner of your monitor’s bezel) of your MultiSync brand monitor in the table below. Follow the removal procedure to detach the original base from your monitor using the diagrams on the following pages and attach the IntelliBase to your monitor.
MultiSync Monitor Model Names | Original Monitor Base |
Removal and IntelliBase | |
| Installation Instructions |
MultiSync 50, MultiSync 70, XV15 and | Page 3 |
XV15+ |
|
|
|
MultiSync XE15, XE17, XP15, XP17, XV17, |
|
XV17+, A500, A500+, A700, A700+, | Page 5 |
A900, E500, E700, E900, E900+, M500, |
|
M700 and P750 |
|
|
|
MultiSync XE21, XP21, E1100, E1100+, | Page 7 |
P1150 and P1250+ |
|
|
|
2 |
|