Battery Safety

V600UserGuide.book Page 33 Tuesday, March 21, 2000 8:26 AM

Safety

Caution: Never operate your projector without the lamp module or lamp module door. Doing so may damage the projector.

Caution: Proper ventilation is important. Don’t block ventilation openings. Never operate this projector in an enclosed area. Do not place the projector on a tablecloth or other soft covering that may block the vents. With ceiling installations, use approved mounting hardware. Do not put the projector near heat ducts, air cleaners, transformers or other electrical devices. For permanent installations follow local codes.

Caution: Do not touch the glass portion of the new lamp module with your hands or allow it to touch other objects as this may damage it and shorten its operational life.

Caution: Do not drop the lamp module as the glass may shatter.

•Read and follow all warnings and instructions supplied by the battery manufacturer.

•Keep batteries away from children.

•Store batteries in their original packaging.

•When inserting batteries, verify that the (+) and (-) terminals are aligned correctly.

•Replace all batteries of a set at the same time.

•Do not mix new batteries with used ones.

•Do not use batteries of different chemistries, capacities, brands or sizes together. Leakage could result.

•Do not disassemble, recharge, or short-circuit batteries.

•Do not subject batteries to high temperature or fire.

•Discard used batteries according to all applicable local and national regulations.

•In the unlikely event of contact with battery electrolyte, customers in the U.S. can contact the Kodak Information Center (KIC) at 1-800-242-2424. U.S. customers can also contact KIC for information regarding electrolyte removal from KODAK product components. Customers outside the U.S. can contact their local Kodak Customer Service representative.

English