Kodak i260, i250 manual Power Setup, Manufacturer’s power supply

Page 17

Power Setup	Several power cords are supplied with the scanner. Use only the cord required
	for your type of power. Dispose of the unneeded power cords properly.
	Use only the power supply that was provided with the scanner.
	CAUTION: The power supply must only be used indoors in a dry location.
	IMPORTANT: Do not substitute another power supply model or another
	manufacturer’s power supply.
	1. Press the side labeled “O” on the power switch to make sure that the
	power is off.

On/Off (I/O) switch

NOTE: The power switch is on the power supply.

2.Attach the power cord for your power type to the power supply.

3.Attach the power supply to the power input on the back of the scanner.

4. Plug the power cord into a power outlet.

NOTE: Make sure that the power outlet is located within 1.52 metres (5 feet) of the scanner and is easily accessible.

5.Press the side labeled “I” on the power switch to power up the scanner.

After you power up the scanner, the red and green indicator lights will illuminate. After approximately one minute, both lights go out. When the green indicator light comes back on, the scanner is ready to begin scanning. However, the host computer may require a few more seconds to detect the scanner.

12	A-61167 September 2002

Image 17

Contents Page User’s Guide Contents Troubleshooting Using the ScannerMaintenance Appendix D Kodak i200 Series Dockable Flatbed Appendix E Installing Optional MemoryAppendix C Kodak i200 Series Imprinter Introduction Scanner FeaturesMaintenance Paper Transport FeaturesSpeed/Capacity Throughput 200 dpiRecommended Documents Preparing Documents for ScanningUser Precautions Safety InformationPage Acoustic Emission Power SystemEMC Statements Site Specifications System Requirements Installing the ScannerUnpacking the Scanner Registering Your Scanner Front Removing Foam Sheet Scanner ComponentsInternal RearSide Making Connections Manufacturer’s power supply Power SetupPage Page Tray Extenders and Side Guides Adjusting the Output Tray Starting and Stopping Scanning Automatic Feeding Using the ScannerDamaged Documents Continuous FeedingManual Feeding Cleaning Separator Module MaintenanceCleaning the Scanner Separator module Front roller cover Page Imaging Guides CleaningReplacing Separator Module Replacing Wear PartsReplacing the Feed Module 1. Power down the scanner Click Calibrate Calibrating the ScannerIndicator Lights Lamps Clearing Document Jams TroubleshootingAdjusting Separator Module Tension System Is Not Responding Color Image Quality Problem Possible Solution Problem SolvingTransporting the Scanner Maintenance sectionAppendix a Specifications Dockable Flatbed Weight DimensionsOperating Temperature Feature Power ConsumptionCatalog No Appendix B Supplies and AccessoriesAppendix C Kodak i200 Series Imprinter Contents of the Imprinter KitRemoving Circuit Board Cover Installing the ImprinterAttaching the Imprinter Board and Cable Support slot Imprinter connector Page Page Completing the Imprinter Installation Page Installing Ink Blotter Strips Purging an Ink Cartridge Installing an Ink Cartridge Setting the Imprinter Position Imprinting Problems Imprinter MaintenanceWhen the Imprinter Is Not in Use Replacing an Ink Cartridge Expected Life of ImprinterReplacing the Ink Blotter Strips Replacing Ink Cartridge Carrier Printable Character Set Print CharactersImprinter Specifications Appendix D Kodak i200 Series Dockable Flatbed Contents of the Dockable Flatbed Kit Flatbed SpecificationsInstalling the Dockable Flatbed Remove the scanner front panel Book Scanning Using the FlatbedClick Calibrate Cleaning the Flatbed After a Power Failure Removing the Dockable Flatbed Press firmly against the right side of the door to latch it Appendix E Installing Optional Memory Circuit board cover Remove the existing memory card from the main control board Eastman Kodak Company