GX — End of job
HA — Set mode
HC — Next image address
The GX command initiates the scanner End of Job sequence. This sequence includes:
• turning off the feeder
• flushing the transport
• turning off the transport
• disabling scanning
NOTE: The image buffer is not cleared.
Data Field | Command Field | |
none | G | X |
The HA command changes the current scanner configuration to the configuration defined by the specified application mode.
| Data Field | Command Field | ||
| mode | H |
| A |
|
|
|
|
|
Data Field | Description |
|
| Value(s) |
mode | mode number |
|
NOTE: Only one Set Mode command may be sent with each SCSI Send command.
The HC command sets the image address for the next document.
|
| Data Field |
|
| Command Field | |||
STX |
| image address | ETX |
| H |
| C | |
|
|
|
|
|
|
|
|
|
Data |
|
|
|
|
|
|
|
|
Field |
| Description |
| Value(s) |
| |||
STX |
| start of transmission indicator |
| 02H |
| |||
Image |
| the image address which is to be | see |
| ||||
Address |
| assigned to the next document |
| NOTES |
| |||
ETX |
| end or transmission indicator |
| 03H |
|
NOTES:
•The image address format must be compatible with the current application mode. It must be sent to the scanner as if it were entered on the scanner operator control panel. It should only be sent when the scanner is idle.
•STX and ETX are optional when specifying
|