Kodak 6B6640 manual Printer devicename

				Troubleshooting
Code	Status Message	Possible Cause/Subsystem		Possible Solution
117	A software error has been	An error has occurred on the	Resolve printer error condition.
	detected by the following	printer.
	device: _devicename_ Error
	Message: _errmsg_
118	A SCSI ID for the following	SCSI driver not found.	Reinstall the SCSI driver on host
	device was not found:		computer.
	_devicename_.
119	The wrong SCSI ID was	SCSI ID is incorrect.	Set the Target SCSI ID to the
	specified for the following		printer SCSI ID.
	device: _devicename_.
120	This device has been setup	The chosen device has not been	Verify chosen device matches the
	for the wrong model of	found.	printer model.
	printer: _devicename_.
121	Unable to read STATUS from	Unable to see the printer.	Check SCSI cable connections.
	device: _devicename_.
122	The selected LUT contains	Trying to send a 12-bit LUT to a	Select a 10-bit LUT file.
	data that exceeds the limits	10-bit printer.
	of this printer.
201	An error occurred while	The system is trying to allocate	Close any unnecessary
	trying to allocate memory.	memory; however, no memory is	applications.
		available.
202	The following parameter is	An internal error occurred with the	•	Restart the application.
	invalid:_parametername:	software.	• If problem continues, call for
	_parametervalue_.			service.
203	The function is not supported	An internal error occurred with the	•	Restart the application.
	by the class.	software.	• If problem continues, call for
				service.
204	This function has not been	An internal error occurred with the	•	Restart the application.
	implemented.	software.	• If problem continues, call for
				service.

March 2001 2-5