CHAPTER 4 PRINTER OPERATION
2. Printing with manually fed media
When printing through the bypass slot, perform the following procedure.
NOTE
•Only one sheet of paper can be set onto the bypass table at a time.
•When using curled paper, smooth the paper. If the curling persists, place the paper with the curled surface up.
1Adjust the bypass guides to the paper size indications on both sides of the bypass table.
3 | Perform the appropriate printing procedure on your |
computer. |
NOTE
Refer to the
4 | When the message “Set paper. bypass” appears, refer to |
Step 2 and set the next sheet onto the bypass table. Printing |
will start. Repeat this procedure to set sheets one at a time onto the bypass table until the required number of sheets has been loaded and printed.
2 | Set the paper face down all the way into the feed slot aligned |
with the paper size indication. |
When placing paper in the bypass table, set the paper quickly all the way into the feed slot. Once the paper is fed, release the paper. If the paper is not set properly, a paper jam may be detected.
If the paper is set obliquely, pull the paper out and then insert it again.