Kyocera FS-1700 user manual Using the Mode Select Menu, Function Default Setting

2.3.Using the Mode Select Menu

2.3.Using the Mode Select Menu

This section explains how to use the MODE key on the control panel. The MODE key allows you to set or change the printer environment such as the number of copies to make, emulation, page orientation, code set, etc. to your specific needs.

The following items can be selected by using the MODE, + and -, and ENTER keys. Also, the diagram on the last page in this manual gives a quick reference to the full options and the sequence of selec- tion.

Mode Select Menu

Item	Function	Default Setting
,      -	Selects the interface on which the control panel set-	Parallel
	tings are effective. This setting affects only the cur-
	rently active interface.
	Parallel setting has a sub item in which one of four
	data transmission modes can be selected —
	. ""/0 01, , ., or	Nibble (high)
	) 0 
	Serial setting has five sub items, and sets the follow-
	ing RS-232C/RS-422A parameters:
	Baud rate	9600
	Data bits	8
	Stop bits	1
	Parity	None
	Protocol	DTR(pos.)&XON
	If an optional network board is installed, also makes
	the network settings.
."   	Sets the number of copies to be printed.	001
$       -	Changes the emulation mode on the current inter-	HP LaserJet 5M
	face. The key allows access to sub item
	-  .
           -	Selects the bitmap or scalable font for the current	Bitmap
	interface. Sub items allow selection of typefaces and
	scaling of the scalable font. For example, you can
	select one of the Courier fonts as the default font for
	printing.
   	The + and - keys toggle between portrait and land-	Portrait
	scape page orientations.
2 *       -	Reads information from the option ROM installed in	—
	the printer's main board.
*$*3     -	Reads or writes data from or to an memory card in	—
	the printer's memory card slot. Also, this menu
	allows deletion of data from an memory card; and
	formatting the memory card.

2-12