Kyocera FS-1700 specification

5.5 Indicators and Messages

Message	Corrective Action
$3 &&	This message appears when an error occurs during access to the memory card
.,.+$	using the PRESCRIBE IIe RWER (ICCD) command or from the printer's control
	panel. Look at the error code given in place of && and refer to the corresponding
	description given below. Please note that error codes of <'and above only result
	when memory card operations are done fromthe control panel.
	<>:Data or memory card capacity is too large.
	• This error code appears if an attempt is made to write more than 32 MB of data
	to a memory card or if the capacity of the memory card installed in the printer
	is more than 32 MB. Decrease the data being written to the memory card to
	less than 32 MB. Note that only memory cards of 32 MB and less can be used
	by this printer.
	• This error code appears when a data name not existing on the memory card is
	specified.
	Check the data names on the memory card.
	<;: The memory card does not meet specifications. This memory card cannot
	be used by this printer. Insert a memory card which can be used by this printer.
	(See "Memory Cards" of Chapter 2.)
	<?: The memory card is not a JEIDA card. Only JEIDA Ver. 4.2 memory cards can
	be used by this printer.
	<: The card is an S-RAM or flash card which cannot be used by this printer.
	<: There is no battery in the memory card. Replace the battery in the memory
	card with a new one.
	<!: The memory card is write-protected. Cancel the write-protection of the
	memory card.
	<@: The memory card requires formatting. Format the memory card from the
	control panel.
	<': The capacity of the memory card is insufficient. This error code appears
	when an attempt is made to write more data on the memory card than available
	memory. To halt the writing of data, first stop data transmissions from the com-
	puter, and then the printer's CONTINUE key. Press the FORM FEED key if the mes-
	sage will appear in the message display. The message display will
	return to reading .
	>>: The memory card is full of data items. The number of data items which can
	be written on the memory card is limited to 127. Pressing the CONTINUE key will
	restore the message in the message display.
	>?: This is a logical error. Try substituting another flash memory card.
	>@: The flash memory card cannot be written due to insufficient printer memory.
	Either delete unnecessary macros and/or fonts stored in the printer, or expand the
	printer's available memory.
	>A: This is a write error. Try substituting another flash memory card. (Error codes
	>? through >A apply only to flash memory cards.)

-	The amount of memory available for the fonts header parts of font is too small to
	load more fonts. Try deleting unnecessary fonts and macros.

,B	This message is displayed when you attempt to use the printer's control panel to
	change the environmental settings on the interface from which data are presently
	being received.

5-10

Message

when memory card operations are done fromthe control panel.

<>:Data or memory card capacity is too large.

return to reading  .

return to reading .