Quick Start, To attach the Base to the LCD Stand

NEC LCD19WMGX user manual Quick Start, To attach the Base to the LCD Stand

Quick Start

To attach the Base to the LCD Stand:

1.Insert the front of the LCD Stand into the holes in the front of the Base (Figure 1).

2.Next, position the locking tabs on the back side of the LCD Stand with the holes on the Base. Lower the Stand until locking tabs are secure.

Figure 1

Stand
Locking Tabs	Front Base

To attach the AccuSyncLCD monitor to your system, follow these instructions:

1.Turn off the power toyour computer.

2.For the PC or MAC with DVI digital output: Connect the 24-pin DVI signal cable (not included) to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your system (Figure A.2). Tighten all screws.

For the MAC: Connect the MultiSync Macintosh cable adapter to the computer, then attach the

15-pin mini D-SUB signal cable to the MultiSync Macintosh cable adapter (Figure A.3). Tighten all screws.

For the DVD Player: Connect the HDMI to DVI-D adapter to the DVD player. Attach the DVI signal cable to the HDMI to DVI-D adapter (Figure A.4). Tighten all screws.

NOTE: To obtain the AccuSync Macintosh cable adapter, call NEC Display Solutions of America, Inc. at (800) 632-4662.

3.Connect the15-pin mini D-SUB cable to the appropriate connector on the back of the monitor. (Figure B.1) Connect one end of the audio cable to AUDIO-INPUT on the back of the monitor and the other end to the “Audio Out” terminal on the computer.

4.Connect one end of the power cord to the LCD and the other end to the power outlet. Place the video signal cable, power cord, DVI cable, and audio cable into the cable holder between each hole of the stand neck. Insert the tabs of the cable holder until it clicks. (Figure B.1)

NOTE: Adjust the position of cables in the holder to avoid damage.

NOTE: Refer to Recommended Use section of this manual for proper selection of power cord.

5.Turn on the monitor with the front power button and then turn on computer. (Figure C.1)

6.No-touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial setup for most timings. For further adjustments, use the following OSD® controls:

• Auto Adjust Contrast

• Auto Adjust

Refer to the Controls section of this User’s Manual for a full description of these OSD controls.

NOTE: For download information on the Windows® INF ﬁle for your NEC monitor, visit www.necdisplay.com.

NOTE: If you have any problems, please refer to the Troubleshooting section of this NEC User’s Manual.