NEC PA271W Canadian Department of Communications Compliance Statement, Declaration of Conformity

Page 4
Canadian Department of Communications Compliance Statement

Canadian Department of Communications Compliance Statement

DOC: This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

C-UL:Bears the C-UL Mark and is in compliance with Canadian Safety Regulations according to CAN/CSA C22.2 No. 60950-1.

FCC Information

1.Use the attached specifi ed cables with the MultiSync PA241W/MultiSync PA271W color monitor so as not to interfere with radio and television reception.

(1)The power supply cord you use must have been approved by and comply with the safety standards of U.S.A., and meet the following condition.

Power supply cord Length

Plug shape

Non shield type, 3-conductor

2.0m (PA241W), 3.0 m (PA271W)

U.S.A

(2)Please use the supplied shielded video signal cable, 15-pin mini D-SUB to DVI-A cable or DVI-D to DVI-D cable. Use of other cables and adapters may cause interference with radio and television reception.

2.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used

in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult your dealer or an experienced radio/TV technician for help.

If necessary, the user should contact the dealer or an experienced radio/television technician for additional suggestions. The user may fi nd the following booklet, prepared by the Federal Communications Commission, helpful: “How to Identify and Resolve Radio-TV Interference Problems.” This booklet is available from the U.S. Government Printing Offi ce, Washington, D.C., 20402, Stock No. 004-000-00345-4.

Declaration of Conformity

This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions. (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

U.S. Responsible Party: NEC Display Solutions of America, Inc.

Address:

500 Park Blvd, Suite 1100

 

Itasca, Illinois 60143

Tel. No.:

(630) 467-3000

 

 

Type of Product:

Display Monitor

Equipment Classifi cation: Class B Peripheral

Models:

MultiSync PA241W (L249TU)

 

MultiSync PA271W (L279TV)

We hereby declare that the equipment specified above conforms

to the technical standards as specified in the FCC Rules.

English-2

Image 4 Contents
MultiSync PA241W MultiSync PA271W User’s ManualIndex Declaration of the Manufacturer DeclarationEnglish Canadian Department of Communications Compliance Statement Declaration of ConformityFCC Information We hereby declare that the equipment specified above conformsContents Product FeaturesEnglish-3 Quick Start Figure A.3Figure A.4 Figure A.1Figure C.1a Figure C.1Figure C.2 Figure C.3Raise and Lower Monitor Screen Figure D.1Figure E.1 Figure RL.1Screen Rotation TiltSwivel Figure R.1Flexible Arm Installation Remove Monitor Stand for MountingFigure S.1 Figure F.1SETTING OSD LANGUAGE ControlsAuto Adjust Analog input only*1 AUTO ADJUSTBrightness/Contrast Controls Image ControlsADJUST ADVANCED SETTINGColor Control Systems FINE Analog input only*1OFF TIMER ToolsPIP MODE PIP INPUTRESOLUTION NOTIFIER MENU ToolsOFF MODE LANGUAGEFACTORY PRESET ECO InformationInformation OSD WarningUsing the PICTURE MODE function The type of PRESETPRESET PURPOSEAdvanced OSD English-17 English-18 English-19 AnalogEnglish-20 English-21 English-22 English-23 Safety Precautions and Maintenance Recommended useEnglish-24 Cleaning the LCD Panel Cleaning the CabinetErgonomics English-25Specifications - PA241W Monitor SpecificationsMultiSync PA241W English-26Specifications - PA271W Quick Release stand Allows fast removal FeaturesEnglish-28 English-29 Troubleshooting LED on monitor is not lit no green, blue or amber color can be seenNo Video Self DiagnosisUSB Hub does not operate English-31Using the Auto Brightness function SETUPCongratulations TCO’03 for MultiSync PA271WErgonomics EnergySome of the Usability features of the TCO Certified for displays Some of the Environmental features of the TCO Certified for displaysTCO Displays 5.0 for MultiSync PA241W This display is designed for both you and the planetManufacturer’s Recycling and Energy Information Disposing of your old NEC productEnergy Saving WEEE Mark European Directive 2002/96/EC
Related manuals
Manual 36 pages 652 b