NEC colour monitor appendix Installation, Connection to your Personal Computer

English Deutsch Fran•ais Espa–ol Italiano Appendix

Installation

Connection to your Personal Computer

The MultiSync LCD2110 true colour monitor complements PC compatible computers. Your system has one of two configurations:

–the video controller is built into the computer.

–the video controller is in the form of a display card (sometimes referred to as graphics card, video adapter or graphics board).

Both configurations have a video connector (or a CRT PORT on laptop computers). If you are not sure which connector is the video connector, refer to your computer or display card manual.

To attach the MultiSync LCD2110 monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.Connect the 15-pin mini D-SUB of the appropriate signal cable to the connector of the display card in your computer (Figure A.1) (Figure B.1). Tighten all screws.

NOTE: Some Macintosh systems require a Macintosh cable adapter.

3.Remove connector cover on back of monitor. Connect the BNC cables and AC adapter cable to the appropriate connectors on the back of the monitor.

If you are using the supplied video signal cable, continue to step 4. If you are using a 15-pin mini D-SUB cable (not included), please skip to Step 5.

4.Connect the red BNC cable to the BNC connector on the monitor labeled R, the green BNC cable to the BNC connector labeled G/Sync, the blue BNC cable to the BNC connector labeled B. If you have a fourth BNC connector (Composite Sync), connect it to the BNC connector on the monitor labeled HS/CS. If you have a fifth BNC connector (Vertical Sync), connect it to the BNC connector on the monitor labeled VS