Lexmark Z12 Electronic emission notices, Additional rights, Industry Canada Compliance Statement

Page 28

damages. This is true even if you advise Lexmark or a Remarketer of the possibility of such damages. Lexmark is not liable for any claim by you based on a third party claim.

This limitation of remedies also applies to any developer of materials supplied to Lexmark. Lexmark’s and the developer’s limitations of remedies are not cumulative. Such developer is an intended beneficiary of this limitation.

Additional rights

Some states do not allow limitations on how long an implied warranty lasts, or do not allow the exclusion or limitation of incidental or consequential damages. If such laws apply, the limitations or exclusions contained in this statement may not apply to you.

This warranty gives you specific legal rights. You may also have other rights which vary from state to state.

Electronic emission notices

Federal Communications

Commission (FCC)

Compliance Information

Statement

The Lexmark Z12 Color Jetprinter has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including

•

•

24 •• Appendix

•

interference that may cause undesired operation.

The FCC Class B limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult your point of purchase or service representative for additional suggestions.

The manufacturer is not responsible for any radio or television interference caused by using other than recommended cables or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void the user's authority to operate this equipment.

Note: To assure compliance with FCC regulations on electromagnetic interference for a Class B computing device, use a properly shielded and grounded cable such as Lexmark part number 1329605 for parallel attach or 43H5856 for USB attach. Use of a substitute cable not properly shielded and grounded may result in a violation of FCC regulations.

Any questions regarding this compliance information statement should be directed to:

Director of Lab Operations

Lexmark International, Inc. 740 West New Circle Road Lexington, KY 40550 (606) 232-3000

Industry Canada Compliance Statement

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Avis de conformité aux normes d’Industrie Canada

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.

European Community

(EC) Directives

Conformity

This product is in conformity with the protection requirements of EC Council directives 89/336/EEC and 73/23/EEC on the approximation and harmonization of the laws of the Member States relating to electromagnetic compatibility and

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Lexmark Z12 United States Government Restricted Rights Contents Energy Star Power supply Safety information Printer parts IndexFor information about setting up your printer, refer to Insert the appropriate print cartridgeLoad the print media To the left edge of the mediaPrinting Loading banner paperCustomize the printer settings Choose Print or Printer SetupOpening the Printer Properties from an application Open the application’s File menuPrinting ClickFollowing table Print your documentSelect Normal 600dpi or High 1200dpi Print Quality Using the Control Program Programs Lexmark Z12 Series Lexmark Z12 Control ProgramStatus tab to Cartridge tab toMake sure the Power light is On Installing or replacing your print cartridgeImproving print quality Install the replacement cartridge Select the type of cartridge you installed and click OKPrinter Close the front coverAligning the print cartridge Cleaning print nozzlesClick OK Maintaining your printer Wiping print nozzlesStoring an extra print cartridge Preserving print cartridgesTo remove a print cartridge from the storage unit Troubleshooting Category for the solutionGrounded electrical outlet Printer is turned OnPrinter prints slowly or doesn’t print Not selectedYour Lexmark printer is set as the default printer Printer prints very slowlyPrinter ejects a blank page after appearing to print Make surePaper misfeeds or jams Test page does not printPaper misfeeds Printer does not feed envelopesPress the Power button to turn the printer Off Document prints with mistakes or poor qualityPrinter has a paper jam Vertical straight lines are not smoothPrint smears on Print nozzles are clean. For help, seePrint is too dark or smudged Problems with transparencies or envelopes Printer settings I selected changedCharacters are missing or unexpected Transparencies stick togetherError messages and flashing lights Power light blinks twicePaper Jam message Ink Low messageInstalling printer Using diskettesUsing the CD-ROM Using the World Wide WebUninstalling printer software Statement of Limited WarrantyWarranty Printing from DOSWarranty service Extent of warrantyAppendix Limitation of liabilityElectronic emission notices Additional rightsAvis de conformité aux normes d’Industrie Canada European Community EC Directives ConformityPower supply Safety informationEnergy Star Japanese Vcci notice United Kingdom Telecommunications ActPrinter parts Index IndexInk cartridge Opening From an application Warranty statement 22 Web Smoothing

Z12 specifications

The Lexmark Z12 is a compact color inkjet printer that gained popularity for its affordability and vibrant output quality. As a budget-friendly option designed for home and small office users, it combines ease of use with fundamental functionality.

One of the primary features of the Lexmark Z12 is its resolution capabilities. The printer offers a maximum print resolution of 4800x1200 dpi, which ensures sharp text and colorful images. Whether users are printing documents, photos, or graphics, the Z12 delivers impressive results, making it suitable for various printing needs.

The Z12 utilizes a four-color ink system, which consists of black, cyan, magenta, and yellow cartridges. This setup enables the printer to create a wide range of colors and shades, enhancing the visual appeal of printed materials. The ink cartridges are straightforward to replace, and users can choose to use either standard or high-capacity cartridges, depending on their printing volume requirements.

In terms of speed, the Lexmark Z12 can print up to 11 pages per minute (ppm) for black text and approximately 8 ppm for color prints. While it may not compete with higher-end models, this performance level meets the needs of everyday home and small office users who prioritize convenience.

The Z12 is equipped with a user-friendly interface, utilizing a simple control panel with an easy-to-read LCD display. Additionally, it connects via USB, enabling straightforward setup with compatible devices. The printer is compatible with various operating systems, including Windows and Mac, ensuring broad usability for different users.

Moreover, the Lexmark Z12 incorporates various energy-saving technologies, such as automatic power-off features and energy-efficient printing modes. This functionality not only reduces power consumption but also contributes to the overall sustainability of printing practices.

Overall, the Lexmark Z12 stands out as a reliable and economical printing solution for users seeking quality output without the need for advanced features. Its combination of simplicity, vibrant color reproduction, and user-friendly design solidifies its place in the entry-level inkjet market. For households and small businesses looking for a dependable printer to handle standard printing tasks, the Lexmark Z12 presents an excellent choice.
Top Page Image Contents