⇒Selecting Manual configuration enables you to statically assign to your NetTool an IP address that complies with your network’s addressing scheme. This applies if your network does not use DHCP or if you just prefer to manually configure it.
⇒Select the address you wish to configure (example to the right shows NetTool IP address Edit screen).
afq48s.bmp
afq47s.bmp
⇒On the Edit screen use the up and down arrow keys to enter each number of the IP address one at a time (right and left arrow keys move the cursor over) until you enter the whole address.
⇒Press Select after you have entered a valid IP address for your NetTool. NetTool then lists the updated address with the subnet and router IP addresses.
⇒Enter the subnet mask and default router IP addresses in the same way to complete manual configuration.
Note
For manual configuration, make sure any IP address you assign to your NetTool is correct for the subnet you are on. You must also enter a valid subnet mask and default router IP address.
31