Philips LTC 2600 manual Manual Reset System4 models only

LTC 2600 Series Section 1 Introduction

•Manual Reset (System4 models only):

Enable: Press ACT key, and all action(s) will be reset.

Disable: All actions will follow the action dwell time as programmed.

•Camera History (System4 models only): By switching on CAMERA HISTORY, the front panel keys will

flash for cameras that were in Action once the ACT key is pressed. The Action can now be cleared by pressing individual camera keys or all can be cleared at once by pressing the ACT key again.

•Audible Alarm: The LTC 2600 Series provides an Audible alarm.

Enable: When an action occurs, the beeper will sound for the duration of the action. Press any key to turn the beeper Off.

Disable: Beeper disable.

•Action Output Relay: The multiplexer has one output relay for standard models and two for System4 models.These relays can be programmed to switch on for actions (refer to VCR Setup section for programming relay response to action).

•Multiple Actions: Individual actions will be recorded for the programmed ACTION DWELL time or until the action is cleared. If two or more actions are active at the same time, video is alternately recorded until the dwell time expires or the action conditions are cleared.

Action call-up is only viewed on MON B. For multiple actions, MON B will sequence the action video at two-second intervals.

LTC 2622 series only: Action call-up is automatically viewed in cameo 1 of the multiscreen display mode. For multiple actions, cameo 1 will sequence the action video at two-second intervals.

22