Philips 42HFL5580, 32HFL5530 user manual Problems and Solutions, Service Remote Battery OK

>A number display shows from 1~100 the percentage of memory storage progress from the Wireless Smart-Loader to the TV (100 = fully loaded).

SMARTLOADER TO TV -------- ##

>When data transfer is completed, ## is “100”, the following menu appears for 3 seconds:

TV READY >

>After that, the following menu comes up

GOODBYE >

> The TV goes to standby now and your TV is installed and ready for start-up and use.

Problems and Solutions:

Problem	Solution
The message “WRONG VERSION” is	The program stored into the Wireless Smart-Loader has a
displayed on the screen.	software code incompatible with the actual TV.
	Reprogram the Wireless Smart-Loader from a master TV
	whose software code is compatible with the actual TV.
TV doesn’t respond to the Wireless Smart-	-check if the LED on the Wireless Smart-Loader is green when
Loader.	pressing any button and check if the batteries are in a good
	condition. Replace batteries if necessary.
	- try to bring the Wireless Smart-Loader more closer to the
	TV infra red receiver and try again.

Tips:

1.Do not forget to write the software code and the type of relevant master TV on the sticker used on the back of the Wireless Smart-Loader.

2.The Wireless Smart-Loader can retain without batteries, the stored information for ten years if required.

Note:

Before putting the Wireless Smart-Loader into store for a long time, make sure that the batteries are all taken out to prevent the batteries corroding the contacts.

Low battery check

Press the OK key for approximately 5 seconds. The following text then appears:

SERVICE

1 REMOTE BATTERY OK

If the word “LOW” appears instead of “OK”, the remote control batteries are low and must be replaced.

21