Philips 240B1CS/00 user manual Common Problems, Imaging Problems

Troubleshooting

￿Safety and	Troubleshooting
Troubleshooting
￿FAQs
	This page deals with problems that can be corrected by a user. If the problem still persists after you have tried these
￿Common Problems	solutions, contact Philips customer service representative.
￿Imaging Problems	Common Problems
￿Regulatory Information
	Having this problem	Check these items

● Make sure the power cord is plugged into the power outlet

No Picture		and into the back of the monitor.
	●	First, ensure that the power button on the front of the monitor
(Power LED not lit)
		is in the OFF position, then press it to the ON position.

	● Make sure the computer is turned on.
No Picture	● Make sure the signal cable is properly connected to your
	computer.
(Power LED is white blinking)	● make sure the monitor cable has no bent pins on the connect
	side. If yes, repair or replace the cable.
	● The Energy Saving feature may be activated
Screen says
	● Make sure the monitor cable is properly connected to your
	computer. (Also refer to the Quick Set-Up Guide).
	● Check to see if the monitor cable has bent pins.
	● Make sure the computer is turned on.

AUTO button doesn't function in VGA mode

Imaging Problems

Image is not centered

●The auto function is applicable only in VGA-Analog mode. If the result is not satisfactory, you can do manual adjustments via the OSD menu. Note that the Auto Function is not applicable in DVI-Digital mode as it is not necessary.

●Press the Auto button.

●Adjust the image position using the Phase/Clock of Setup in OSD Main Controls.

file:///E/LCD%20Monitor%20OEM/Philips/M1-project/240B1/240B1-EDFU/5B.0V601.001/lcd/manual/ENGLISH/240B1/safety/saf_troub.htm 第 1 頁 / 共 3 [98-06-05 10:25]