Philips 196V4L user manual Remove Base Stand, Resolution notification, Physical Function Tilt

Page 9

2. Setting up the monitor

Resolution notification

This monitor is designed for optimal performance at its native resolution, 1366 × 768 @ 60 Hz.When the monitor is powered on at a different resolution, an alert is displayed on screen: Use 1366 × 768 @ 60 Hz for best results.

Display of the native resolution alert can be switched off from Setup in the OSD (On Screen Display) menu.

Physical Function

Tilt

2.3 Remove Base Stand

Remove the Base Stand

Before you start disassembling the monitor base, please follow the instructions below to avoid any possible damage or injury.

1.Place the monitor face down on a smooth surface, taking care to avoid scratching or damaging the screen.

2. Press the locking clips to detach the base stand away from the base column.

1

3. Detach the base column.

2

7

Image 9

Contents Troubleshooting & FAQs Table of Contents Safety precautions and mainte- nance MaintenanceOperation Temperature 0-40C 32-95F ServiceNotational Descriptions Disposal of product and packing material Waste Electrical and Electronic EquipmentTaking back/Recycling Information for Customers Installation Setting up the monitorPackage contents Install base standOperating the monitor Connecting to your PCModel 196V4L OSD MenuRemove Base Stand Resolution notificationPhysical Function Tilt Remove the Base Stand100mm Image Optimization SmartContrastPhilips SmartControl Lite Start with Standard pane Adjust menu Color menu Image Optimization At startup will not load when this box is unchecked Disabled Tune Display Opens the SmartControl Lite control panel Technical Support displays the tech supportExit Close SmartControl Lite Picture/Display Monitor Panel Type Technical SpecificationsBacklight 196V4LA0C to 40 C 196V4L30,000hrsLED EnvironmentalResolution & Preset Modes Maximum Resolution1366 x 768 @ 60 Hz analog input Power Management Definition Power ManagementEpeat Electronic Product Environmental Regulatory InformationThis product is in conformity with the following standards GS EK1-20002009 GS mark requirementReorient or relocate the receiving antenna Declaration of Conformity for Products Marked with FCC LogoCet équipement a été testé et déclaré Regulatory Infomation Placering/Ventilation Paikka/IlmankiertoPlassering/Ventilasjon China RoHS ʳʳʳʳʳʳʳʳʳʳʳʳEU Energy Label Philips’ Flat Panel Monitors Pixel Defect Policy Customer care and warrantPixels and Sub pixels Types of Pixel DefectsDark subpixel Total bright dot defects of all typesAdjacent dark subpixels Total black dot defects of all typesCustomer Care & Warranty Lithuania UAB Servicenet Bulgaria LAN ServiceTopaz-Service Company +38 044 245 73 Russia BelarusAL Shahd Computer L.L.C Contact Information for Apmea regionMake sure the computer is turned on TroubleshootingPower on light is too strong and is disturbing General FAQsQ2 What is the recommended refresh rate for LCD monitor? Image appears blurred, indistinct or too darkQ7 How should I clean the LCD surface? Q4 How do I adjust the resolution?Q6 Is the LCD screen resistant to scratches? Q10 Are Philips LCD monitors Plug-and- Play?Troubleshooting & FAQs Koninklijke Philips Electronics N.V. All rights reserved