zReset the monitor to the factory preset via the OSD menu
zAccess the Geometry Menu in the OSD of the Monitor and perform the necessary adjustments
zChange the monitor timing to the recommended resolution
19.The picture appears too dim. How can I correct this?
Adjust Brightness and/or Contrast via the monitor 's OSD. Some models have a Video Input Select
under Advanced Controls in the monitor 's OSD. Most computers require it to be set at 0.7V.
Please review the following for possible solutions:
zIf the OSD menu is also dim, please contact service for repair
zReset the monitor via the OSD menu
zChange the color temperature settings to 9300 color coordination via the OSD menu
zSet the Contrast to maximum level (100) and Brightness to middle level (50)
20.How can I increase the color display of my monitor?
The amount of video memory your video card holds determines the amount of colors that can be displayed on your computer screen. To get the most out of your video card, you will need to either install the latest drivers onto your computer or upgrade the video cards memory. Please check with your computer or video card manufacturer for further details.
21. Why is there no picture on my monitor?
zCheck the wall socket for power. Verify that there is power by connecting another product.
zEnsure the power cable is correctly attached to both the wall socket and the monitor.
zCheck that the power button is switched on.
zUnplug the monitor for approx. 1 minute and plug it in again. Switch the monitor back on.
22.Why is there no picture on my monitor even though the power LED is yellow/amber or flashing green?
zReboot your computer while holding the Ctrl key on your computer. If you see any picture during the boot procedure, please verify the settings of your video card (for Windows go to Control Panel and select Display).
zCheck that the video cable is not damaged, bent or that any of the pins in the connector are damaged (please be aware that some VGA connectors have one missing pin). If damaged, replace with a new cable.
zCheck that the cable is attached correctly to the computer.
zPress any key on the keyboard to
23.Why is there no picture on my monitor even though the power LED is green?
zVerify the Contrast and Brightness setting of the monitor. First press and hold the 5
button to increase Contrast and then press and hold the 4 (+) button to increase Brightness. These buttons are located on the front of your monitor.
zPress both the
zTry and repeat step 48 above.