TECHNICAL SUPPORT (FAQ)
ENGLISH
Problem & Question
Power LED is not on
No Plug & Play
Picture is fuzzy
Picture bounces or a wave pattern is present in the picture
The power LED is ON (orange) but there’s no video or no picture
Missing one of the primary colors (RED, GREEN, or BLUE)
Possible Solution
*Check if the Power Switch is in the ON position
*Power Cord should be connected
*Check if the PC system is Plug & Play compatible
*Check if the Video Card is Plug & Play compatible
*Check if the
*Make sure the Monitor Drivers are installed
*Adjust the Contrast and Brightness Controls.
*Move electrical devices that may cause electrical interference.
*Computer Power Switch should be in the ON position
*Computer Video Card should be snugly seated in its slot
*Make sure monitor’s video cable is properly connected to the computer.
*Inspect monitor’s video cable and make sure none of the pins are bent.
*Make sure computer is operational by hitting the CAPS LOCK key on the keyboard while observing the CAPS LOCK LED. The LED should either turn ON or OFF after hitting the CAPS LOCK key.
*Inspect the monitor’s video cable and make sure that none of the pins are bent.
10
Philips_manual_
Tuesday, November 18, 2003 3:00:46 PM