Philips Kvaser LAPcan II manual How to use the DRVcan

Page 10

Kvaser LAPcan / LAPcan II Hardware Guide

10(19)

 

 

6.2How to use the DRVcan

Push firmly to insert the connector on the DRVcan into Kvaser LAPcan.

To remove the connector, push both tabs (see Figure 3 below) as deep as possible and pull out the connector.

We recommend that you remove the card before inserting or removing DRVcans. This is because not all software will be able to handle a “hot- swap”. No damage to your Kvaser LAPcan will happen, however, if you insert or remove a DRVcan while the Kvaser LAPcan is inserted into your computer.

Kvaser AB, Mölndal, Sweden — www.kvaser.com

Image 10
Contents Kvaser LAPcan / LAPcan II Hardware Guide Kvaser LAPcan / LAPcan II Hardware Guide 219 Table of Contents About this manual Introduction Kvaser LAPcan installation Technical data, Kvaser LAPcan and Kvaser LAPcan DRVcans Typical DRVcanDRVcan Types NameHow to use the DRVcan D-SUB connector Few Words of CautionKvaser LAPcan / LAPcan II Hardware Guide 1219 DRVcan configuration Reserved, do not connectOrange Not connected Black Shield Red Power is required Technical Data for DRVcan Technical Data for DRVcan DNoptoTechnical Data for DRVcan S Technical Data for DRVcan FiTechnical Data for DRVcan LIN EMC Compliance EMC TestsDocument revision history