Philips PPX1430 Initial Operation, Connect power supply / charge battery, Initial Installation

3 Initial Operation

Connect power supply / charge battery

CAUTION!

Mains Voltage at the Site of Installation!

Check whether the mains voltage of the power supply matches the mains voltage avail- able at the setup location.

1Insert the small plug of the power supply into the socket on the rear side of your device.

2Plug the power supply into the mains.

3During the charging process, the indicator light on the top of the device will be red. When the battery is fully charged, it will turn green.

4Charge the built-in battery before using for the first time for at least 3 hours. This will prolong, the life of the battery.

Initial Installation

1Switch the device on using the on/off switch on the side.

2Turn the device towards an appropriate projection surface or wall at a distance of at least 0,2m and at most 3m. Make sure the projector is in a secure position.

3Use the focus wheel on the top to adjust the image sharpness.

4Select the desired menu language using ¡/¢.

5Confirm with à.

Notice

The main menu appears instead of the language selection

The device has already been installed. In order to change the menu language, pro- ceed as follows:

1Select with the navigation keys Settings.

2 Confirm with à.

3 Select using ¡/¢ Language.

4 Confirm using à.

5 Select the desired language with ¡/¢.

6 Confirm with à.

7 You can exit with ¿.

Installing or Changing the Batteries of the Remote Control

DANGER!

Risk of explosion with incorrect type of batteries

Use only batterytype:CR 2025.

CAUTION! RISK OF EXPLOSION IF BAT- TERY IS REPLACED BY ONE OF AN INCORRECT TYPE.

1To access the battery, disengage the locking mecha- nism (‚) and slide out the battery compartment (ƒ).

2Insert the new batteries into the battery compart- ment with the positive and negative poles as shown on the back of the remote control. Make sure the polarities(+ and -) are aligned correctly.

8 Philips · PPX1430