Philips Garbo manual Time, Menu bar appears on the screen

Lamp replacement

B

6. Maintenance <

5Unscrew screw B.

6Grasp the lamp holder handle and carefully pull the lamp holder out of the projector.

• Do not tilt. If the inner tube is broken glass particles may fall out.

• Keep lamp holder opening to your right. Do not touch lamp or point lamp holder opening at anyone.

7Carefully remove the new lamp housing from its package.

•Always use the same type of lamp: LCA3116/00 (132 W), 12nc: 8670 931 16009.

•Do not touch lamp or point lamp housing opening at anyone.

•Do not drop, as the impact may cause the lamp to break.

8Place the lamp holder in the guiding slots and insert into the lamp compartment.

9Tighten screw B again.

B

A

10Put the lamp door back in place and press tab A back in its original position.

– The Mains inlet socket will open again.

11Insert the mains lead into both the projector Mains inlet socket and the wall socket.

12Press the Standby button to switch on the projector.

13Reset the lamp life time (see ‘Resetting the lamplife time’).

14Dispose of the old lamp in special chemical disposal bins.

Resetting the lamplife	1 Press Menu.
time	– The menu bar appears on the screen.

AV	Source
Mute
Stand	Lamp
by	Temp

MenuOK

Picture Display Audio Settings

(previous) Start-up screen Lamp counter Auto standby Auto source Feedback

Lamp 0 hours

Lamp counter shows the operating hours of the lamp. It is suggested to reset when a new lamp is inserted. To reset keep OK key pressed

for 3 seconds.

2Use cursor control to select ‘Settings’ in the menu bar.

3Use cursor control to select ‘Lamp counter’ in the sub menu.

4Press OK for 3 seconds to reset the lamp counter.

5If required, select another item you wish to adjust or press Menu to exit.

Philips Home Cinema Projector

English User guide Garbo 29