Black Box LP004A manual

Page 55

BLACK BOX→ Power Over Ethernet Switch(PoE) Installation and User Guide

When a RJ-45 cable connection is made, and each time a LINK is enabled, auto-negotiation takes place. The LP004A advertises its capability for 10 or 100 Mbps speed and F/H duplex mode, and the device at the other end of the cable should similarly advertise / respond and both sides will agree to the speed and mode being used. Depending upon the device connected, this will result in agreement to operate at either 10 Mbps or 100Mbps speed, full- or half-duplex mode.

4.3Dual LEDs, Front-panel and side-panel (LP004A Series) LED Description

PWR Illuminates GREEN to indicate power applied.

LK/ ACT Steady ON for LINK w/no traffic, blinking for activity per port. LINK will turn off in the event connectivity is lost between the ends of the twisted pair segment or a loss of power occurs in the unit or remote device. The Link ports are also represented by LA1, LA2, LA3, LA4 (Steady ON for Link or steady OFF indicates no Receive Activity).

10/100 Steady ON for 100Mb speed, OFF for 10Mb speed per port

42

Image 55

Contents January2006 LP004A Power over Ethernet PoE SwitchTrademarks Contacting Black Box Corporation Phone 724Iii Page Page Page Vii Page Page Specifications Operation Revisions Network Standards Ports PerformanceCold Start Operating Environment Ambient Temperature ratingsStorage Temperature Maximum Ethernet Segment or Domain LengthsCooling Method PackagingTemperature un-controlled Extreme Ratings -40 to 75C Power SupplyLED Indicators Dual front and top Port ConnectorsAgency Approvals and Standards Compliance Mounting optionsSummary of models and descriptions LP004A Series AccessoriesInspecting the Package and the Product Product Description LP004A Series Page Page Page Page Black Box LP004A with four RJ-45 Copper ports Page Black Box LP004A, as shown in is Black Box LP004A-Series, with four RJ-45 Copper ports Frame Buffering and Latency Page Page Two sets of LEDs for viewing status from any angle Rugged metal case, Industrial grade DC Power input for LP004A PoE SwitchPage Video Example 4b. LP004A Power Source Switch for PoE device onlyPage NCM Locating the PoE Switch Unit Page Page Page LP004A is shown alongside DIN-Rail-MC2 bracket DIN-Rail mounting optionPower Requirement for Black Box LP004A Power Source Switch Power Output Power Consumption of the unit DC Power Terminals +, -, gndLP004A , DC-powered, -48VDC Installation GND can be hooked up at the last Connecting Ethernet MediaMedia Ieee Standard Connector Page Dual-Speed Functionality, and Switching Switching, Filtering and Forwarding Auto-cross MDIX, Auto-negotiation and Speed-sensing Switching, Address LearningPage Troubleshooting Before Calling for Assistance When Calling for Assistance