Black Box IC133C-R2, IC187C manual Introduction, Factory Default Settings

Page 10

CHAPTER2: Introduction

2.3 Factory Default Settings

The Adapter’s factory-default settings are as follows:

Table 2-1. Factory-Default Settings

Port #

Electrical Specification

Port 1

RS-232

Port 2

RS-232

For your reference, record installed Adapter settings below.

Table 2-2. Installed Adapter Settings

Port #

Electrical Specification

Port 1

Port 2

9

Image 10

Contents Port RS-232/422/485 PCI Host Adapter FCC and IC Statements Port RS-232/422/485 PCI Host Adapter NOM Statement Trademarks Table of Contents Contents Specifications Number of Ports 2 RS-232/422/485 Connectors 2 DB9 maleOverview IntroductionWhat’s Included Factory Default Settings IntroductionCard Setup RS-485 Enable ModesCard Setup Address and IRQ selection Line TerminationName Function RS-232 and RS-422/485 Electrical Interface SelectionDIV1 DIV2 DIV4 Clock ModesBaud Rates and Divisors for the Div1 Mode 10. Clocking mode divide byFor this Data Rate Choose this Divisor Baud Rates and Divisors for the Div2 mode Divisors for the Div 2 Mode Installation Setting Up the Operating SystemInstalling the Hardware InstallationTroubleshooting Serial Utility DisketteCalling Black Box Shipping and PackagingAppendix a Interrupt Handling Purpose and Early History of InterruptsWhy Use an Interrupt Status Port ISP? Appendix B Connector Pinouts RS-232RS-422/485 Appendix C Electrical Interfaces RS-422RS-485 Figure D-1. Bit diagram for asynchronous communication Appendix D Asynchronous CommunicationAppendix D Asynchronous Communication Appendix E Board Layout J2CPage Page Copyright 2000. Black Box Corporation. All rights reserved