Black Box ME444AE-530-R3, ME444AE-R3, ME445C-35 Functional Description, Line driver block diagram

Page 12

CHAPTER 2: Introduction

2.2 Functional Description

This section describes the operation of the line driver’s circuit blocks, primarily the circuits required for correctly configuring the modem (see Figure 2-1 below).

Figure 2-1. Line driver block diagram.

2.2.1ENCODER MODULATOR

The encoder modulator receives data from the DTE, then modulates the data using the “conditional diphase modulation” technique. You can configure the encoder to operate in one of three modes:

4-wire full-duplex (point-to-point)

4-wire half-duplex (point-to-point)

4-wire multipoint

The appropriate mode is determined by the setting of two jumpers: CARRIER (J2) and RTS-CTS DLY (J4). For multipoint applications, two additional jumpers must be set: XMT IMP (J13) and RCV IMP (J10). See Section 3.3 for a more detailed explanation of the correct jumper settings.

11

Image 12
Contents Kbps Line Driver FCC and IC RFI Statements Safety Warnings Declaration of Conformity Kbps Line Driver V.35, RS-530, or NOM Statement Trademarks Used in this Manual Contents Specifications Flow Control NoneSpecifications Introduction Physical DescriptionLine driver block diagram Functional DescriptionModulation Timing Applications Point-to-point applicationTail-circuit application Configuration Placement of the Standalone VersionInstalling the Card Version in the RackNest 2/14 Description of the Racknest 2/14’S Power Supply Configuring the Standalone or Card Version User-configurable optionsUser-configurable options Layout of the 256-kbps Line Driver circuit board Kbps Line Driver V.35, RS-530, or Installation Installing the Standalone Version in 19-Inch RacksInstalling a single unit in a 19-inch rack Installing two units in a 19-inch rack Installing the 256-kbps Line Driver Rackmount Card Version Installing a card in the RackNest 2/14RackNest 2/14 illustrated Function Installation Kbps Line Driver V.35, RS-530, or Signal ITU-TSS Lead Name Abbrev Circuit Type Rack Norm Nest PIN Pinout of the V.35 standalone’s M/34 connector DB25 DA15 Connecting Data Cables Line Connection Installation Controls and Indicators OperationOperation Operating Procedure IndicatorsTroubleshooting Bit-Error-Rate Tester BertLoop Tests Bert using loops Modem Self-Test Local Analog LoopbackLocal analog loopback Remote Digital Loopback Local Digital Loopback Remote digital loopbackCalling Black Box Local digital loopbackShipping and Packaging Appendix Maximum Distances 19-AWG 22-AWG 24-AWG 26-AWG Kbps MilesCopyright 2004. Black Box Corporation. All rights reserved