Auto Shutdown—Sets the projector lamp to automatically shut down if it doesn’t receive an input signal within 30 minutes.
•Press the 
buttons to select this option.
ON—The lamp will automatically shut down in 30 minutes if it doesn’t receive a signal
OFF—The lamp will remain lit, even if no signal is received
OSD Timeout—Sets the duration the OSD menus remain on the screen before automatically closing if you don’t make a selection.
•Press the 
buttons to increase or decrease the OSD Timeout duration.
Menu Position—Sets the position of the OSD menus on the screen.
•Press the 
buttons to select the menu position as indicated by the icons.
OSD Transparency—Sets the amount of transparency of the OSD menus on the screen. As transparency increases, the image underneath the menus becomes more visible. At the setting of 4, the menus are at maximum transparency; at 16 the menus are opaque.
•Press the 
button to increase the transparency.
•Press the 
button to decrease the transparency.
Factory Reset—Resets the projector’s settings to their default factory settings.
•Press the 
buttons to select the Factory Reset, then press the Menu button on the projector’s control panel or the
button on the remote control to confirm the reset.
Audio Menu
Volume—Adjusts the overall volume.
•Press the 
button to decrease the volume.
•Press the 
button to increase the volume. Mute—Mutes the audio.
•Press the 
buttons to mute the audio.
ON—The audio is muted.
OFF—The audio plays normally.
